Specifications - Hitachi Koki NT 65M2 Bedienungsanleitung

SPECIFICATIONS

Type of power
Air pressure (Gauge)
Applicable nails
Numbers of loadable nails
Size
Weight
Nail-feeding method
Hose (inside dia.)
NAIL SELECTION
Only nails shown in the Table below can be driven with this Nailer.
16 Gauge finish nails
STANDARD ACCESSORIES
(1) Case ............................................................................. 1
(2) Hexagon bar wrench for M6 screw ........................... 1
(3) Hexagon bar wrench for M5 screw ........................... 1
(4) Hexagon bar wrench for M4 screw ........................... 1
(5) Eye protector .............................................................. 1
(6) Oiler ............................................................................. 1
(7) Nose cap (mounted on tool) ...................................... 1
APPLICATIONS
Nailing as finishing process for areas around the
doors, windows as well as edgings.
Securing the bottom of drawers. Making various cases
and cabinets.
PREPARATION PRIOR TO OPERATION
1. Prepare the hose
Be sure to use the hose provided with minimum
6 mm (1/4") inside diameter.
NOTE
The air supply hoses must have a minimum working
pressure rating of 10.4 bar (150 psi.) or 150 percent of
the maximum pressure produced in the air supply
system, whichever is higher.
Piston reciprocating
4.9 – 8.3 bar (70 – 120 psi.)
ref. Fig.
100 nails (2 strip)
295 mm (L) × 285 mm (H) × 71 mm (W) (11-5/8" × 11-7/32" × 2-51/64")
1.7 kg (3.7 lbs)
Spring type
6 mm (1/4")
Min.
2.8 mm (.110")
1.4 mm
(.054")
Dimensions of nails
1.65 mm
(.065" )
2. Check on safety
CAUTIONS
Unauthorized persons (including children) must be
kept away from the equipment.
Wear eye protector.
Check the retaining screws which fix the exhaust
cover, etc. for tightness.
Check the nailer for air leaks and defective or rusty
parts.
Check whether or not the push lever works correctly.
Also check whether or not any dirt has adhered to the
moving parts of the push lever.
Recheck on operational safety.
BEFORE USE
1. Check the air pressure
CAUTION
The air pressure must be constantly maintained at
4.9 – 8.3 bar (70 – 120 psi.).
Adjust the air pressure between 4.9 to 8.3 bar (70 –
120 psi.) according to the diameters and length of
nails and hardness of the wood being nailed. Pay
special attention to the output pressure, capacity,
and piping on the air compressor, so that air pressure
does not exceed the specified limit. Note that
excessive pressure may affect overall performance,
service life, and safety.
English
Max.
8