Sauber UVC-129322.2 Gebrauchsanleitung Seite 16

UVC-129322.2
PARTS DESCRIPTION
1. Handle
2. On/off button on the handle
3. Suction level switch
4. 2-in-1 tool, consisting of the furniture nozzle
attachment (17) and crevice nozzle (18)
5. Vent hole
6. On/off button on the handheld unit
7. Battery charge indicator
8. Motor housing
9. Release button for dust bin
10. Dust bin
11. Holder for the handheld unit
12. Charging station
13. Floor nozzle
14. Power adapter
15. Charging contacts on the appliance
16. Release button for floor nozzle
17. Furniture nozzle adapter
18. Crevice nozzle
19. Charging contacts on the charging station
20. Back part of charging station
21. Charging station base
The nozzles
The appliance has three nozzles each intended for specific purposes:
1) The floor nozzle is suitable for large, flat surfaces and has an electrically powered rotating brush. There is a
LED light on the floor nozzle which can light up the area being vacuumed in dark places (e.g. under the bed).
It is suitable for hard floors such as tiles, laminate, parquet, PVC; short pile carpet; rugs and carpets with a
pile height of up to 1 cm.
It is not suitable for deep pile carpet, i.e. rugs and carpets with a pile height of more than 1 cm.
2) The crevice nozzle is suitable for vacuuming material folds, joints, corners, and niches that cannot be reached
with the floor nozzle.
3) 2-in-1 tool: attach the furniture nozzle attachment to the crevice nozzle. It can be used to remove dust from
upholstered furniture, mattresses, sofas, and smaller surfaces.
BEFORE USE
1. Remove all packaging materials and check if all parts have no visible damage.
2. Put the back part (20) on the base (21) of the charging station. Make sure that the charging contacts (19) on
the back part (20) are facing forward.
3. Insert the upper part (24) of the handle (1) into the lower part. Make sure not to pinch the cord.
4. Insert the fastening screw (25) in the opening (26) and use a cross-head screwdriver to screw it tight.
- 15 -
EN