Problem Solving Guide; Technical Data - Miele SG-Serie Gebrauchsanweisung

en

Problem solving guide

Many malfunctions and faults that can occur in daily operation can be easily
remedied. You can save time and money in many cases, as you do not need to call
the Miele Customer Service Department.
Information to help you rectify faults yourself can be found at www.miele.com/ser-
vice.
The following tables are designed to help you to find the cause of a malfunction or
a fault and to resolve it.
Problem
The vacuum cleaner
switches off automatic-
ally.
On certain models, the
overheating protection
warning light  also
comes on.

Technical data

(for models with radio controlled handle)
Frequency band
Maximum transmitting power
64
Cause and remedy
A temperature limiter switches the vacuum cleaner
off automatically if it gets too hot.
This can occur if, for instance, large articles block the
suction tube or when the dustbag is full or contains
particles of fine dust. A heavily soiled motor protec-
tion or exhaust filter can also be the cause of over-
heating.
 Switch the vacuum cleaner off immediately using
the On/Off footswitch . Switch off at the wall
socket and unplug it.
After removing the cause, wait for approximately 20–
30 minutes to allow the vacuum cleaner to cool
down. It can then be switched on again.
433.05 MHz – 434.79 MHz
< 10 µW