Disposal And Recycling; Troubleshooting - Scheppach 5905801901 Originalbetriebsanleitung

Please provide the following information in the event
of any queries:
• Type of current for the motor
• Machine data - type plate
• Engine data - type plate
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.

15. Disposal and recycling

The device is supplied in packaging to avoid
transport damages. This packaging is raw ma-
terial and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and plas-
tics. Take defective components to special waste dis-
posal sites. Check with your specialist dealer or munic-
ipal administration!

16. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Water is not being
pumped
Water is not getting any
cleaner
24 | GB
Possible cause
Pump not connected
Pump defective
Line is soiled
Pump and filter incorrectly posi-
tioned in relation to each other
Pond is too large
UVC lamp defective
UVC lamp too weak
Filter is soiled
www.scheppach.com
Do not throw old equipment away with household
waste!
This symbol indicates that this product must
not be disposed of in household waste as per
Waste Electrical and Electronic Equipment di-
rective (2012/19/EU) and national laws. This
product must be handed over at the intended collection
point. This can be done, for example, by returning it
when purchasing a similar product or delivering it to an
authorised collection point for the recycling of old elec-
trical and electronic devices. Improper handling of
waste equipment may have negative consequences for
the environment and human health due to potentially
hazardous substances that are often contained in elec-
trical and electronic equipment. By disposing of this
product properly, you are also contributing to the effec-
tive use of natural resources. Information about collec-
tion points for old devices can be found at your munici-
pal authority, the local disposal provider, an authorised
location for the disposal of old electrical and electronic
devices or your waste collection service.
Remedy
Connect the pump.
Repair by an authorised service centre.
Clean the line.
Read the instructions carefully and carry out the
assembly process correctly.
Choose a larger model.
Replace the UVC lamp.
Adhere to replacement interval.
Use twist-clean function.