Tecfrigo SNELLE 700 RBT BIS Zusammenbau Und Betrieb Seite 6

Operator's guide:
1. Unpacking instructions
2. The handles
3. Round glass shelves
I
4. Square glass shelves
5. Grid shelves
UK
6. Cleaning of the internal glass panels
7. Connection to mains
D
8. Controls
9. Checking the correct functioning
E
10. Internal cleaning
F
!
WARNINGS
NL
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
P
1 . Adults should operate this appliance only. Do not allow children to use the controls or play with it.
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
S
installation of the appliance should be carried out by a qualified electrician or other competent person.
4
. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
DK
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs. 6
FIN
7 . The manufacturers of this appliance accept no responsibility for the consequences of misuse in
contravention of these safety instructions. It further reserves the right to carry out improvements without
8
prior notice.
B
sources of heat (such as radiators, stoves, etc) and drafts (such as windows, doors, ventilation systems,
air conditioning, etc ...).
GR
that the products displayed on the shelves and grills do not hang over the edges.
products to be refrigerated should cause ice to form on the evaporator, we recommend stopping the
CZ
compressor and placing the goods in special refrigerated containers, kept at the same temperature, until
defrosting is completed;if this is not carried out the compressor will continue to operate leading to a
EE
wasteful consumption of electricity and poor performance.
it is indispensable to keep the door open at least 10 cm.
LV
!
Our products are for internal use only do not install outside restaurants, shops
LT
H
M
1. UNPACKING INSTRUCTIONS
CARDBOARD PACKAGING 1a
PL
upwards. WOODEN CRATE
fork-lift truck between the appliance and pallet or crate. . Lift the appliance.
SK
crate. . Place the appliance on horizontal level surface, adjusting it using the suitable feet. 5
attention anything is left inside the packing.
SLO
easier disponsal
2. THE HANDLES
1. The handles can be found in a bag inside the appliance. . Fix the base of the handle using the two
screws already inserted in the holes on the door post; wrench down the screws.
over the handle and press down until it clicks into place (see fig. 2).
3. ROUND GLASS SHELVES
1 . The shelves, to be found into a carton box, should be slid into the supports placed in the vertical
rotating frame (first introduce the mirror shelf, in the lower position).
using the screws contained into the pack inside the appliance.Tighten with care (see picture 3).
4. SQUARE GLASS SHELVES
1 . The supports and the suction cups (n.4 for each shelf) are into a pack, inside the appliance. . Insert
the suction cup heads into the supports holes, pushing downwards
hook on the vertical frames slits
carton box, should be put on their supports. . First place the mirror shelf, in the lower position.
the other shelves on the wet suction cups
5. GRID SHELVES
1
.The supports are in a pack inside the appliance. . Fix the supports, inserting the hook on the vertical
frames slits ( ), pushing them downwards ( ).
on the supports, their raised edge opposite to the door (see picture 5).
g
model
(see picture 10).
5
. Avoid installing the cabinet directly in line with sunlight. .
10 . Keep the ventilation grills free from obstruction for at least 30 cm.
. Cut surrounding tape. Remove the cardboard packaging by sliding
1b . Remove the nails from the wooden crate with care.
(see picture 1).
R
model
model
(B),
pushing them downwards
G
model
B
Operator's guide
11. Replacement of internalight
12. Replacement of the door magnetic gasket
Maintenance manual (Page 48):
1. Cleaning the condenser
2. Cleaning the evaporator
3. Replacement of a glass panel
4. Wiring diagram diagram of refrigeration unit
13 . If the appliance is not working and unused,
3
7. Separate the packing materials according to their type, for
2
Q
(C). 4.
5
(See picture 4).
2
C 3 . The grid shelves are into a carton box. Place the grid
6
3
9
Never install the appliance near
12 . If damp air or
2 . Insert forks of
4. Remove the pallet or
6.
3. Place the plastic insert
2 . The shelves have to be fastened
(A). 3 . Fix the supports, inserting the
The shelves, to be found into a
2 . It
11 .Ensure
Pay
2
6. Press