Silk'n Infinity H3103 Bedienungsanleitung Seite 44

U
After each pulse, move the treatment surface (#2) to the next spot. Keep
doing this pulsing action for the area you are treating.
U
Avoid gaps or overlaps as you use the device.
Gliding is the best technique for treating larger parts of the body.
Press the treatment surface (#2) firmly against your skin and slowly glide over your
skin (either across or down as shown in the image). Make sure that the treatment
surface (#2) is always touching your skin.
U
At lower energy levels, the device takes only 1-1.5 seconds to recharge
between pulses. This generates a nonstop sequence of flashes.
EN
U
Glide at a speed so that you avoid gaps or overlaps.
C
Do not treat the same area of skin more than once per hair removal session.
C
Stop use immediately if you have any pain.
5.5 Exposure to the sun
U
The lowest energy level (1) is designed for safe use even after sun exposure.
U
If you use energy levels 2-5, avoid further exposure to the sun for 4 weeks
before and 2 weeks after your treatment. This is because higher
quantities of melanin expose the skin to greater risk when using any
method of light-based hair removal. This applies to all skin types, even
those that don't seem to tan quickly.
U
We don't advise it, but if you have to go out in the sun after a treatment, be
sure to apply sunscreen SPF30 or higher to the treated area. Do this for 2
weeks after a treatment.
5.6 Exposure of pulsed light to the eyes
U
Although you can use the device to treat facial hair, take extra care to avoid
contact with the eyes, and use only below the cheekbones.
The device will only emit repeated pulses when it is in firm contact with your
a
skin, and you keep moving it across your skin.
42