Initial Use - Siemens CT636LE 6-Serie Gebrauchsanleitung

en

Initial use

Button E
Press button E to open the selection
of service programmes. Run the desired
programme as described in the section
"Service programmes"�
Button B
Press button B to open the selection
of "Personalised beverage preparation"�
Personal settings for coffee drinks can
be saved and called up (see the section
" Personalised drinks")�
Button G
Press button G after selecting a drink to
prepare two cups simultaneously (see the
section "Two cups at once")�
F
Press A, E, B
or G again to exit the respective
menu�
Button C
Press C to either begin preparing
a drink or launch a service programme�
Press C again while the drink
is being prepared to prematurely halt
dispensing�
Rotary selector
Turn the rotary selector to navigate in the
display or to change parameters�
Display (Touchscreen)
Information is shown on the display, or
settings can be made by touching the
touchscreen (see the section "Display")�
Initial use
General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans. Do not use coffee beans
that have been glazed, caramelised or
treated with other additives containing
sugar, since they will block the brewing unit�
A
Before the appliance can be switched
on and used, it must be assembled
and connected according to the
enclosed assembly instructions�
42
Setting up the appliance
■ Remove any protective plastic film.
F
Important: Only use the appliance
in a frost-free room� If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use�
■ Take hold of the appliance door by the
recessed grip and open�
■ Remove the water tank, rinse it and fill it
with fresh water up to the "max" mark�
■ Replace the water tank and click into
place�
■ Remove the bean container, fill with
coffee beans and replace.
■ Set the mains switch to I and close the
appliance door�
The appliance heats up and is rinsed�
The display is activated�
"Select language" appears�
■ Turn the rotary selector to select the
desired language and touch [ Continue ]
in the display�
"Set water hardness" appears�
F
It is important to set the water hard-
ness correctly to enable the appli-
ance to accurately indicate when the
descaling programme should be run�
The preset water hardness is level 4�
If a water softener is installed in the
house, please set the water hard-
ness to level 3. You can also check
the water hardness by asking your
local water supplier�
■ Use the enclosed test strip to determine
the water hardness. Briefly dip the test
strip in water and check the result after
one minute�
Level Water hardness
German (°dH) French (°fH)
1 1-7
2 8-14
3 15-21
4 22-30
■ Turn the rotary selector to set the water
hardness determined�
■ Touch L� "Home Connect" appears�
1-13
14-25
26-38
39-54