Cleaning The Rotary Brush - SOLAC Turbobat Power 29.6V Gebrauchsanleitung

Downloaded by: pd-oliana on 19-04-2023 12:26 CEST
opening button (L)
- Extract the cyclone by turning to the left, as
indicated by the arrow and the padlocks located
on the cyclone.
- Remove the HEPA filter from its anchor by
turning the filter to the left, as indicated by the
arrow and the padlocks.
- Wash the different filters and let them air dry.
- To reassemble the filter, proceed with the above
instructions, in reverse order.
OUTLET FILTER: (FIG.4)
- Press the button to open the outlet filter lid (G)
and pull out the filter from the anchorage
- Wash the filter and let it air dry.

CLEANING THE ROTARY BRUSH:

- To remove the brush:
- At the bottom of the brush, move the tab located
at the bottom of the brush towards the open
padlock to disengage the roller and pull to remo-
ve it. (Fig. 5).
- Remove the brush and clean.
- To reassemble, follow the above instructions but
in reverse.
SUPPLIES:
- Supplies can be acquired from distributors and
authorised establishments (such as filters, shoe
brush and battery set) for your appliance model.
- Always use original supplies, designed specifi-
cally for your appliance model.
- These supplies are available in specialist shops.
HOW TO REMOVE THE BATTERIES FROM
THE DEVICE:
- CAUTION: It is important that the batteries are
fully discharged prior to its withdrawal from the
apparatus.
- CAUTION: the appliance must be disconnec-
ted from the supply mains when removing the
batteries.
To remove the batteries, once the life of the
appliance, proceed as follows:
- Remove the battery from the product by pres-
sing the battery removal button (N) and pulling
it out. (Fig.6)
USER MANUAL_AE2515.indb 15 USER MANUAL_AE2515.indb 15 10/03/2023 13:40:00 10/03/2023 13:40:00