Cleaning And Maintenance; Cleaning The Appliance - SOLAC AE2540 Gebrauchsanleitung

CLEANING AND MAINTENANCE

n
Before you clean or perform any maintenance work on the appliance, ensure that it is
unplugged from the mains.
CLEANING THE DUST COLLECTOR AND FILTERS
)
When the dust stored in the collector reaches the maximum fill level, you must empty
it. For optimum performance, you are advised to clean the collector and filters after
each use.
When you need to empty the dust collector, ensure that the appliance is disconnected and
proceed as follows:
1 Push the collector release button (11) downwards and remove the collector. (fig. 5).
2 Remove the filter unit (12-13-14) by holding the collector firmly and pulling the filter
tongue outwards. (fig. 5). Shake the filter unit over a bin or use a brush to clean it
thoroughly.
3 Once you have removed the collector filters, empty the collector into a bin.
4 To clean the filters thoroughly, remove the case (12) by rotating anticlockwise and
remove the filter (13) from the bracket by pulling it outwards (fig. 6).
5 If it is very dirty, wash the dust collector and the filters underneath running water using
a gentle detergent (fig. 7).
)
Important: make sure they are completely dry before you replace them in the collector.
Do not dry the filters with a hair dryer.
6 Reposition the filter (13) and the case (12) on the bracket (14).
7 Place the filter unit (12-13-14) in the dust collector, matching the filter air inlet hole up
to the collector air inlet hole and push the filter inwards until it is held firmly in place
inside the collector.
8 Replace the dust collector in the main broom body (1) and match the collector air inlet
hole up to the suction outlet hole (9). Push until it will go no further and the dust collector
release button (11) is fully fitted into place. You will hear a click.
CLEANING THE MULTIPURPOSE BRUSH (fig. 8)
1 Place the release button (22) in the "open" position and remove the cover (23).
2 Remove the rotating brush (21) from its case.
3 Remove any dirt (hair and other fibres) caught in the brush.
If it is firmly stuck you can cut it using scissors.
4 Wash the rotating brush under running water using a gentle detergent.
)
Ensure that it is completely dry before you put it back in place.
5 Position the rotating brush (fig. 9).
6 Place the cover (23) in its case and the release button (22) in the "closed" position.

CLEANING THE APPLIANCE

)
Clean the appliance before you use it for the first time, immediately after each use and
after a long period of non-use. This will guarantee efficient performance and will
increase service life.
n
Make sure no water gets inside the appliance.
1 Clean the outside of the appliance using a damp cloth. Do not use abrasive products
or solvents.
CLEANING AND MAINTENANCE
en
13