Transport And Storage; Troubleshooting - Wolf Garten BR 16 eM Originalbetriebsanleitung

Transport and storage

Transport and storage
Risk of injuries posed by the work tool
¾ Before transport or storage, switch off
the tool and wait until the work tool
comes to a standstill.
¾ Remove the operating arm before trans-
port or storage.
Transport
Secure the tool sufficiently to prevent its uninten-
Î
tional slipping if you are transporting it on or in a
vehicle.
Risk of injuries or material damage
¾ In case of doubt always consult a specialist workshop.
¾ Before any inspection or any work on the device, switch off the motor and remove the operating
arm.
Problem Possible cause
The device switch- The power pack is too hot.
es off.
The power pack is discharged.
The temperature of the device (electronics) is too
high.
Overcurrent release
The device will not The power pack is discharged.
switch on.
Overcurrent release
Power pack temperature too high or too low.
The power pack is defective.
Uneven running, The brush/the edge cutter is faulty.
severe vibration
The fixation of the brush/the edge cutter has
of the brush/of the
detached.
lawn edger.
WARNING!

Troubleshooting

Storage
Clean your device thoroughly at the end of every
Î
season.
Always store the device in a dry and safe location
Î
that is inaccessible to children.
Store the operating arm and the multifunctional
Î
brush with its work tools separately.
Store the operating arm in a cool and dry loca-
Î
tion. Recommended storage temperature ap-
prox. 0 - 23°C
Keep the device and especially its plastic com-
Î
ponents away from brake fluids, petrol, mineral
oil containing products, penetrating oils etc. They
contain chemical substances that can damage,
attack or destroy the plastic components of the
device.
Fertilizers and other garden chemicals contain
Î
substances that may have a highly corrosive
effect on the metal parts of the tool. Therefore do
not store your device near to these substances.
WARNING!
Remedy
Allow the power pack to cool.
Charge the power pack.
Allow the device to cool and if necessary,
clean the ventilation slots
If this occurs again take your device to a
specialist workshop.
Charge the power pack.
If this occurs again take your device to a
specialist workshop.
Allow the power pack to cool down or
heat up.
Arrange for the power pack and oper-
ating arm to be checked by a specialist
workshop.
Consult a specialist workshop.
Consult a specialist workshop.
EN
27