Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Intended use
The multifunctional brush with the surface brush
is only for cleaning small fortified areas on private
properties, as well as using the optionally available
attachment tools such as
- the joint brush for brushing and cleaning joints of
smaller fortified areas on outdoor areas on private
properties
- the edge cutter for cutting lawn edges on smaller
adjacent fortified areas in outdoor areas on private
properties.
as well as for use in accordance with the safety
information and description given in these operating
instructions. The use of the surface or joint brush is
basically only intended for robust stone surfaces.
Any other use is classed as an unintended use.
The user is liable for any damages arising from
unintended use.
Identification plate / symbols
Position
The identification plate and the symbols are located
on the housing of the tool.
Layout (depending on the attachment tool) Q
1 Manufacturer
2 Model number
3 Serial number
4 CE mark
5 Year of manufacture
6 Disposal instruction
7 Safety symbols
8 Guaranteed sound level
9 Rated voltage, type of current
10 Model name
11 Device group
12 Motor speed in rpm
Operating elements
Operating elements R
1 Lock-on switch
2 On/off switch on handle
3 Handle
4 Holding area for the hand / fastening area for the optional
middle handle
5 Operating arm *(with permanently installed power pack)
6 Locking button
7 Protective cover
8 Joint brush (optional accessory)
9 Edge cutter including a small cleaning brush (9a) (optional
accessory)
10 Surface brush
11 Guide wheel (optional accessory)
12 Motor-/gearbox unit
*Necessary operating element (not supplied)
24
Supplementary documentation
Ensure the supplied operating instruc-
tions of the charger and operating arm
are available and that you have read
and understood them before using the
device.
Power pack charging
Only charge the power pack using the char-
ger approved by the manufacturer. The des-
ignations of the approved chargers are listed
in the enclosed CE Declaration of Conformity.
Attention!
The power pack is supplied partially charged. Be-
fore using the tool for the first time, fully charge the
power pack to ensure effective performance.
The power pack is permanently installed in
the operating arm.
Power pack charging must be carried out ac-
Î
cording to the instructions in the supplementary
documentation.
Assembly
Risk of injuries posed by brush tool / cut-
ting tool
¾ Only adjust the tool with the motor
switched off and the work tool at a
standstill.
¾ Before any work on the tool, first remove
the operating arm with the permanently
installed power pack.
¾ Wear safety gloves.
Assembly/disassembly of surface brush
Assembly
Press and hold the lock [A] forward and keep it
Î
pressed 1 .
Insert the surface brush into the gearbox unit 2 .
Î
Release the lock [A].
Î
3 The lock head audibly engages.
Disassembly
Press and hold the lock [A] forward and keep it
Î
pressed 1 .
Remove the surface brush from the gearbox
Î
unit 2 .
Intended use
Start-up
WARNING!
CAUTION!
WARNING!
AB
Werbung
Inhaltsverzeichnis
Fehlerbehebung
