Unauthorized Modifications; Operating Environment; Power Adapter; Operation - Renkforce Cube One Bedienungsanleitung

7.4 Unauthorized modifications

For safety reasons, unauthorised conversions and/or modifications to the product are not permitted (other than
those indicated in these instructions), as this may damage the components and affect the functionality/safety of
the device.

7.5 Operating environment

Always operate the printer in a well ventilated environment.
Do not place the product under any mechanical stress.
Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam and solvents.
Protect the product from high humidity and moisture.
Protect the product from direct sunlight.
Do not switch the product on after it has been taken from a cold to a warm environment. The condensation that
forms might destroy the product. Allow the product to reach room temperature before you use it.

7.6 Power adapter

Do not modify or repair mains supply components including mains plugs, mains cables, and power sup-
plies. Do not use damaged components. Risk of death by electric shock!
Connect the appliance to a wall socket that can be accessed easily.
As power supply, only use the supplied mains adaptor.
Only connect the power adaptor to a normal mains socket connected to the public supply. Before plugging in the
power adaptor, check whether the voltage stated on the power adaptor complies with the voltage of your electricity
supplier.
Never connect or disconnect power adaptors if your hands are wet.
Never unplug the power adaptor from the mains socket by pulling on the cable; always use the grips on the plug.
For safety reasons, disconnect the power adaptor from the mains socket during storms.
Do not touch the power adapter if there are any signs of damage, as this may cause a fatal electric shock! Take
the following steps:
– Switch off the mains voltage to the socket containing the power adapter (switch off the corresponding circuit
breaker or remove the safety fuse, and then switch off the corresponding RCD protective switch).
– Unplug the power adapter from the mains socket.
– Use a new power adapter of the same design. Do not use the damaged adapter again.
Ensure that cables are not pinched, kinked or damaged by sharp edges.
Always lay cables so that nobody can trip over or become entangled in them. This poses a risk of injury.

7.7 Operation

The nozzle becomes very hot during use and can cause burns if touched. Never touch the nozzle during
or shortly after use.
Do not leave the product unattended during use.
Consult an expert when in doubt about the operation, safety or connection of the appliance.
24