Mounting To Concrete Pools; Installation Diagram For Concrete Pools - Behncke B075 Betriebsanleitung

7.2 Mounting to concrete pools

Tiled or with foil lining
Mark the desired water level (normal water level) on the casing towards the inside of the pool in order to
align the enclosed drilling template. The holes must be made using centre punches in accordance with the
instructions on the drilling template and drilled with drill bit appropriate to the casing material.

7.2.1 Installation diagram for concrete pools

Casing
Installation situation for concrete pool B100
Surface Suction Unit Mini Skimmer / Planning information
NOTE
Place the surface suction unit behind the casing and attach in the desired
position (using plastic-coated wires, stable round cord or wooden slats).
When installing the surface suction unit, it must be ensured that there is
contact with the sheathing.
Check whether the protective cover is attached to the surface suction unit.
Secure the surface suction unit using the 4 screws enclosed. To do this,
press the surface suction unit into place from the inside of the pool, align it
horizontally using a spirit level, and then screw in the screws.
The connecting line to the surface suction unit for the suction
(if necessary, the connection with the floor drain too), the filling water supply
feed and overflow are to be tightly connected or glued in by a professional
and guided out of the back of the casing (outer wall side of the pool).
(Curing and setting times must be observed)
Skimmer cover Tile
z.B. 250
Mortar layer
Water line
M6 hexagon
screw for casing
Casing
Concrete
6