❷ Installation; I Setup; I Hose Section Assembly - Zodiac MX6 Montage- Und Gebrauchsanleitung

2.1 I Setup

Hose length necessary
Suction line connection example

2.2 I Hose section assembly

2.2.1 Determine the number of sections you need
• Measure the length between the suction line or the skimmer and the furthest away point of the pool.
• Add an extra 1 metre to the length measured.
• If total length is over 10 metres (MX
to purchase any additional hose sections required for your pool.
Tip: assemble the "right" quantity of hose sections
Assembling more hose sections than the length necessary to cover the whole pool is not recommended.
Hoses that are too long may limit the cleaner's performance.
2.2.2 Twist Lock Hose section assembly
• To easily assemble the two pipe sections using the Twist Lock system, connect them then twist until the connectors
are in complete abutment, in one of the 3 notches providing the seal (see image
• The section of Twist Lock hose with the hose float attached will be connected to the cleaner (see image
Lock hose float must be located 20-23 cm away from the cleaner (see image
5
❷ Installation
6 - MX 630) or 12 metres (MX
TM TM
: Cleaner
: Hose sections
: Pool valves
: Suction line
: Skimmer
: Filtering pump
: Filter
8 - MX 8 PRO - MX 9), contact your reseller
TM TM TM
: Connection to the suction line or
the skimmer
: Hose length necessary
: 1 metre section of hose with
float
: Connection to the cleaner
).
).
20-23 cm
). The Twist
Float