Zodiac MX6 Montage- Und Gebrauchsanleitung Seite 2

GENERAL WARNINGS
• Failure to respect the warnings may cause serious damage to the pool equipment or cause serious injury, even death.
• Only a person qualified in the technical fields concerned (electricity, hydraulics or refrigeration) is authorised to perform this
procedure. The qualified technician working on the appliance must use/wear personal protective equipment (such as safety
goggles and protective gloves, etc.) in order to reduce the risk of injury occurring when working on the appliance.
• Before servicing the appliance, ensure that it is switched off and isolated from the power supply circuit.
• The appliance is intended to be used only for swimming pools and spas; it must not be used for any purpose other than that for
which it has been designed.
• It is important that the appliance is operated by people who are competent and qualified (both physically and mentally), after
having read the instructions for use. Persons not meeting these criteria should not be allowed access to the appliance in order to
prevent risk of property damage of injury, including loss of life.
• Keep the appliance out of the reach of children.
• The appliance must be installed according to the manufacturer's instructions and in compliance with all applicable local
and national standards. The installer is responsible for installing the appliance and for compliance with national installation
regulations. Under no circumstances may the manufacturer be held liable in the event of failure to comply with applicable local
installation standards.
• For any work other than the simple user maintenance described in this manual, the product should be referred to a qualified
professional.
• Incorrect installation and/or use may cause serious damage to property or serious injuries (possibly causing death).
• All equipment, even postage and packing paid, travels at the risks and perils of the recipient. The latter shall issue reserves in
writing on the carrier's delivery slip if damage is detected, caused during transport (confirmation to be sent to the carrier within
48 hours by registered letter). In the event that an appliance containing coolant has been turned on its side, mention your
reservations in writing to the carrier.
• If the appliance suffers a malfunction, do not try to repair it yourself; instead contact a qualified technician.
• Refer to the warranty conditions for details of the permitted water balance values for operating the appliance.
• In addition to using spare parts manufactured by unauthorised third-party manufacturers, deactivating, eliminating or by-passing
any of the safety mechanisms integral to the appliance, will automatically void the warranty.
• Do not spray insecticide or any other chemical (inflammable or non-inflammable) in the direction of the appliance, as this may
damage the body and cause a fire.
• Zodiac® heat pump, filtration pump and filter appliances are compatible with the most commonly used types of pool water
treatment systems.
• Do not touch the fan and/or any moving parts and do not insert anything, including your fingers in the vicinity of the moving
parts while the appliance is in operation.
WARNINGS ASSOCIATED WITH ELECTRICAL APPLIANCES
• The electrical supply to the appliance must be protected by a dedicated 30 mA differential residual current protection device
(RCD), complying with the standards and regulations in force in the country where it is installed.
• Do not use an extension cord to plug in the appliance; connect the appliance directly to a suitable power supply circuit.
• Before carrying out any operations, check that:
- The voltage indicated on the rating plate of the appliance corresponds to the mains voltage,
- The power grid is adapted to the power requirements of the appliance, and is grounded.
- The plug (where applicable) is suitable for the socket.
• In the event of abnormal function or signs of overheating such as an unusual odours from the appliance, turn it of immediately,
unplug / disconnect it from its power supply and contact a professional.
• Before accessing the enclosure for any reason, ensure that all power to the appliance and also power to any accessories or
external devices which may be connected to the appliance, is disconnected from the mains power supply.
• Do not disconnect and reconnect the appliance to the power supply when in operation.
• Do not pull on the power cord to disconnect it from the power supply.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
• Do not attempt to carry out any servicing or maintenance operations with wet hands or while the appliance is wet.
• Ensure that all terminals for mains power are free in good condition and free of corrosion and/or dirt/debris.
• For any component or sub-assembly containing a battery: do not recharge or dismantle the battery, or throw it into a fire. Do not
expose it to high temperatures or direct sunlight.
• In stormy weather, disconnect the appliance from the power supply to prevent it from suffering lightning damage.
• Do not immerse the appliance in water (with the exception of cleaners) or mud.
SPECIFIC FEATURES APPLICABLE TO "Pool cleaners"
• The cleaner must operate in pool water with a temperature of between 15°C and 35°C.
• To avoid possible injury and damage to the cleaner, do not operate the cleaner out of the water.
• In order to prevent possible injury, bathing is prohibited when your cleaner is in the pool.
• Do not use the cleaner during shock chlorination.
• Do not leave the cleaner unattended for an extended period.
WARNING ON THE USE OF A CLEANER IN A POOL WITH A VINYL SURFACE:
• Before installing your new cleaner, carefully inspect the lining of your pool. If the liner has eroded in some areas, or if you notice
gravel, folds, roots or corrosion caused by metal on the inner surface of the liner, or if you notice that the support (bottom
and walls) is damaged, do not install the cleaner before performing the necessary repairs or before replacing the liner using a
qualified professional. The manufacturer cannot be held liable in any way for damage caused to the liner.
• The surface of certain vinyl patterned surfaces can wear rapidly and the patterns disappear on contact from objects such as
cleaning brushes, toys, inflatable buoys, chlorine distributors and automatic pool cleaners. The decoration on some vinyl surfaces
can be scratched or worn by basic friction such as through the use of a pool brush. The colours of certain patterns can also be
erased during use or when in contact with objects in the pool. The erased patterns, wear or scratching of vinyl surfaces are not
the liability of the manufacturer and are not covered by the limited warranty.
Recycling
This symbol means that your appliance must not be thrown into a normal bin. It will be selectively collected for the purpose of
reuse, recycling or transformation. If it contains any substances that may be harmful to the environment, these will be eliminated
or neutralised.
Contact your dealer for recycling information.
1
WARNINGS