Batavus E-go Bedienungsanleitung Seite 39

Article 2 Warranty period
2.1 Batavus frames and rigid front forks are guaranteed against
manufacturing and/or material defects for a period of 10 years.
2.2 Suspension forks, dampers and all other components, except the
components listed in section 2.4 of this article, are covered by the same
warranty for a period of 2 years.
2.3 Paintwork on the frame and fork are covered by a warranty on rusting
from within for 2 years.
2.4 Components that are subject to wear, such as tires, chain, chain rings,
freewheel, rear cogs, cables and brake pads are not under warranty,
except in case of manufacturing faults and/or material defects.
2.5 Other painted or chrome-plated parts are covered by a 2-year warranty,
subject to proper maintenance.
2.6 The electrical components of your E-bike (display, drive system and
battery pack) are covered by a 2-year factory warranty. Do not clean the
bicycle with a pressure washer. A powerful water jet can damage the
electronics. This will void the warranty. The warranty will also be voided
if deep discharge of the battery pack is detected.
Article 3 Guarantee exclusions
3.1. The warranty is void in the following cases:
a. Incorrect and/or careless use of the bicycle or use other than the
intended use;
b. The bicycle is not maintained in accordance with the service manual;
c. Technical repairs are not done competently;
d. Components added later do not correspond with the technical
specifications of the bicycle or are installed incorrectly;
e. If the proof of ownership that shows that the bicycle was
professionally assembled and inspected prior to being supplied to
the customer is not present or not signed by the seller.
3.2. Batavus B.V. further shall not be liable for damage to (components of)
the bicycle as a result of:
a. Incorrect adjustment/tightening of the handlebar, stem, seat, seat
39
39