Device Use; Starting The Engine - hillvert HT-YS-600 Bedienungsanleitung

Mounting the protection frame:
1. Attach the transparent cover to the frame with bolts - Fig. 5.
2. Mount the frame on the machine, as shown on Fig. 6.
Mounting the start cord in holder: Fig. 8A
1. Pull gently the starter cord from the engine.
2. Attach the starter grip on the holder on handlebar.
Mounting the wheel bracket: Fig. 9A
Mounting the 2 pcs wheel bracket by 8 pcs bolt M8x20, 8 pcs nut M8 and 8 pcs washer 8.
Mounting the guard plate: Fig. 9B
Mounting the Lower guard by 6pcs bolt M6x14.
Mounting the guard plate by 1 pc long bolt and 1 pc nut M6.
Safety zone
While the machine is being operated and the motor is running, do not leave the operation zone marked with arrows on Fig.
10. If it is necessary to leave the operation zone, first stop the engine.
3.3.

Device use

Always check the oil level prior to use!
On engines with dipstick the oil level must always be between the min. and max. On engines without dipstick the oil must be
visible to the edge on filler hole, when the engine is horizontal position. Always use SAE-30 oil. Use only unleaded 95 octane
gasoline. Never over-fill the gas tank.
3.3.1.

Starting the engine

1. Pump the fuel 3-6 times – Fig. 8B.
2. Set the gas lever to the max position.
3. Pull the start cord to start the engine – Fig. 8A. Always feed the start cord back into the engine by hand.
4. Activate the brush activation handle.
Stop the engine
1. Release the brush activation handle.
2. Set the gas lever to the stop position.
3.3.2. Work
Remove all foreign objects from the work area before using the machine. Stones, glass, branches and similar items may
damage the machine. Also check the bolts are tightened.
Start the motor as per the instructions above. Stand clear of the machine's moving parts.
Never attempt to move the machine in any way other than intended for normal use while the motor is running
The machine can work on all types of flat surfaces and remove weeds between tiles or edges.
Note that the brushes may sweep stones or other objects away at high speed, so do not drive close to cars and other items
that could be damaged.
Brushes can scratch and damage some tiles. Therefore, run a small test before using the machine.
Always have the protection frame attached during use.
3.3.3. Brush height adjustment
Follow the adjustment procedure as shown in Fig.11+12.
It is possible to adjust the height on the brush head down in several positions as the brushes get worn.
KEEP A SAFETY DISTANCE OF 15 METERS.