Device Description; Assembling The Device - hillvert HT-YS-600 Bedienungsanleitung

3.1.

Device description

HT-YS-600
HT-YW-
600
3.2.

Assembling the device

Please note: Drawings can be found at the end of the manual in section 3.5 Drawings.
Please follow the steps in Figures 2-9:
1. Mount lower handlebar with 4 bolts on the console. After that mount the upper handlebar. The spacers need to be on
the inside. As shown on Fig. 2A.
2. Attach the clutch handle on the handlebar, as shown on Fig. 2B.
3. Mount the wheels with the bolts shown on Fig. 3A. The spacer needs to be between the wheel and the console.
4. Attach the brushes using the bolts and lock washers as shown on Fig. 4.
5. Mount the gas lever on the handle, as shown on Fig. 7.
Drawing 1
A – Start cord
B – Brush activation lever
C – Engine
D – Wheel
E – Brush
F – Brush head
G – Protection guard
H – Protection frame
I – Gas lever