Maintenance - hillvert HT-YS-600 Bedienungsanleitung

Stopping the Engine
To stop the engine in an emergency, simply release the flywheel brake lever.. Under normal
conditions, use the following procedure.
Release the flywheel brake lever.

The flywheel brake lever shown here will be connected to a remote control on the equipment
powered by this engine. Refer to the instruction provided with that equipment for remote
control information.
Setting Engine Speed
Position throttle lever for the desired engine speed .
The throttle lever shown here will be connected to a remote control on the equipment powered by
this engine. Refer to the instruction provided with that equipment for remote control information.
*Note: Not all models do have throttle lever..
Check Engine oil level
Check the engine oil level with the engine stopped.
Remove the oil filler cap, and wipe the dipstick clean.

Insert the dipstick into the oil filler neck, but do not screw it in.

Check the oil level shown on the dipstick. If near the lower, fill to the upper level with the

oil. Do not overfill.
Screw in the filler cap securely.

NOTICE: Running the engine with a low oil level will cause engine damage.
Change Engine Oil
Drain the used oil while the engine is warm. Warm oil drains quickly and completely.
Wipe the oil filler area clean, then remove the oil filler cap/dipstick.

Place a suitable container next to the mower to catch the used oil, then tilt the mower on its

right side. The used oil will drain through the filler neck. Allow the oil to drain completely.
Please dispose of used motor oil and the containers in a manner that is compatible with the
environment. We suggest you take it in a sealed container to your local recycling center or
service station for reclamation. Do not throw it in the trash, pour it on the ground, or pour it
down a drain.
Fill with the recommended oil. Do not overfill. Allow a couple of minutes for the oil to settle

Section 5

maintenance