Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To adjust the height, you have to loosen the two 4mm screws shown in Fig. 11. Then you can adjust the brush head up and
down. Tighten both screws again once the wanted height is chosen.
Make sure to adjust the protection frame upwards too as the brushes get worn and when the brush head is adjusted down.
Or else the rubber cover will be damaged – Fig. 12.
3.4.
Cleaning and maintenance
a)
The machine should be cleaned after use. Use a garden hose to wash off soil and dirt. The chassis number should only be
cleaned with a damp cloth to avoid unnecessary wear. Avoid using a high-pressure washer during cleaning.
b)
Use only non-corrosive cleaners to clean the surface.
c)
After cleaning the device, all parts should be dried completely before using it again.
d)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
e)
Do not spray the device with a water jet or submerge it in water.
f)
Do not allow water to get inside the device through vents in the housing of the device.
g)
Clean the vents with a brush and compressed air.
h)
The device must be regularly inspected to check its technical efficiency and spot any damage.
i)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they may damage the
surface material of the appliance.
j)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or other chemical
substances because it may damage the device.
k)
The oil should initially be changed after the first 5 hours of use, and thereafter once per year. Use an oil extractor kit.
•
Suck the oil up through the oil filler hole using the syringe. Use the hose to reach the sump.
Transfer the used oil to the container.
•
•
Fill the engine with new SAE-30 oil.
Check the oil level using the dipstick.
•
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device recycling and
collection point. Check the symbol on the product, instruction manual and packaging. The plastics used to construct the
device can be recycled in accordance with their markings. By choosing to recycle you are making a significant contribution to
the protection of our environment.
Contact local authorities for information on your local recycling facility.
3.5.
Drawings
Drawing 2:
Werbung
Inhaltsverzeichnis
