Charging The Robot - Philips HomeRun Aqua 7000 Serie Bedienungsanleitung

Charging the robot

- Model XU7100
-
- Model XU7100
-
1
2
Note: Keep 0.5 meters of space on the sides of the station and 1.5 meters
in front of the station.
2 Connect the station to the power supply.
3 Make sure that the remaining part of the power cable is well concealed
behind the station so that the robot cannot drive over it.
Note: For model XU7100 only, place the dust bag in the dust bag
compartment of the station.
1 Turn the robot to its correct position and put the robot on the floor in front of
the station. The water tank should be facing away from the station.
2 Make sure that the station is connected to the wall socket.
3 Press and hold the on/off button for 3 seconds to switch on the robot.
4 Press the home button. The robot drives to the correct position in the station.
5 Wait until the robot is fully charged.
If the battery is empty, the robot will not drive itself to the correct position. In
this case, follow the next steps:
1 Turn the robot to its correct position and put the robot on the floor in front of
the station.
2 Align the wheels with the tracks on the station (for model XU7100) or align
the charge contacts of the robot with the charge terminals of the station (for
model XU7000).
3 Push the robot in and let the wheels go in the tracks (for model XU7100) or
put the robot with the charge contacts on the charge terminals of the station
(for model XU7000).
- Model XU7000
-
- Model XU7000
-
1
2
English
9