Charging The Robot - Philips XU3000/02 Bedienungsanleitung

2
1

Charging the robot

1
2
1 Attach the mop pad holder to the bottom of the water tank of the robot.
2 Slide the straight side of the washable mop pad in the correct slot of the mop
pad holder and attach the washable mop pad to the velcro material of the
mop pad holder.
1 Press the on/off switch on the bottom of the robot to switch on the robot.
2 Turn the robot to its correct position and put the robot on the floor in front of
the station.
3 Make sure that the station is connected to the wall socket.
4 Press the home button. The robot drives to the correct position in the station.
5 Wait until the robot is fully charged.
If the battery is empty, the robot will not drive itself to the correct position. In
this case, follow the next steps:
1 Turn the robot to its correct position and put the robot on the floor in front of
the station. The water tank should be facing away from the station.
2 Align the charging contact points on the front bottom of the robot with the
charging contact points on the station.
English
9