Troubleshooting - cecotec Cumbia POWER ESPRESSO 20 PROFESSIONALE Bedienungsanleitung

ENGLISH

6. TROUBLESHOOTING

Problem
Coffee does not come out
No water/steam
Coffee comes out around
the edge of the portafilter
Coffee is too light
No steam
POWER ESPRESSO 20 PROFESSIONALE
34
Cause
No water in tank.
Coffee grind is too fine.
There is too much coffee in
the filter.
The device is not turned on
or connected to the power
supply.
Coffee has been tamped/
compressed too much.
There is no water in the
water tank or it is not
installed properly.
The machine is not
preheated.
Portafilter not rotated to
full lock position.
There is ground coffee on
the edge of the filter.
There is too much coffee in
the filter.
Coffee is not enough
ground or the grounds are
not pressed enough.
Steam tube is blocked.
The steam knob is not set
to the required position
or preheating is not
completed.
Solution
Add water.
Grind medium-ground coffee.
Fill filter with less coffee.
Connect the unit to a power
supply and turn it on.
Refill the filter basket with coffee,
do not tamp too much.
Fill the tank with water and turn
on the device.
The machine needs to be
preheated before coffee can be
brewed. Once the machine is
preheated, the light indicator will
turn on.
Rotate filter holder to full lock
position.
Wipe off the rim.
Fill with less coffee.
Replace the coffee powder and
flatten it with the measuring
spoon/coffee tamper.
Use a small wire through the
steam hole and make sure to
clean the tube after each use.
Turn the steam knob to the
steam position and wait for the
preheating process to complete.