TFA 35.1133 Bedienungsanleitung Seite 11

TFA_No. 35.1133_Anleit_03_23
Wireless weather station
A4: Battery symbol for outdoor transmitter
A5: Indoor temperature and humidity
A6: Radio controlled clock with seconds, weekday and calendar
A7: Snooze and alarm symbol
A8: DCF reception symbol, DST and PM symbol
Buttons front (Fig. 1)
B1: Light and snooze button
Buttons back (Fig. 2)
B2: MODE button
B3: ALARM button
B4: ▲ button
B5: ▼ button
B6: WAVE button
B7: LIGHT/SNZ button
Housing (Fig. 2)
C1: Battery compartment
C2: Connecting power supply
C3: Stand (fold out)
4. Getting started
• Place the base station and the outdoor transmitter on a desk with a distance of approximately
1.5 meter. Avoid getting close to possible interference sources (Electronic devices and radio
installations).
• Open the battery compartment of the outdoor transmitter.
• Insert two new batteries 1,5 V AAA into the battery compartment of the outdoor transmitter.
Make sure the polarities are correct.
• Remove the protecting foil from the display of the base station.
20
20.03.2023 11:41 Uhr Seite 11
Wireless weather station
• Connect the base station to the attached power adapter. Insert the adapter into the jack at the base
station and connect the power adapter to a wall socket. Important! Make sure that your household
voltage is not higher than 240V! Otherwise your device may be damaged.
• The device will alert you with a beep and all LCD segments will be displayed for a short moment.
• The backlight is activated permanently.
• The indoor temperature will be displayed on the base station and the base station will scan the
outdoor temperature and the reception symbol will be flashing.
• If the reception of the outdoor temperature fails, "- -" appears on the display. Check if there is
any source of interference. After the reception of the radio-controlled time you can start the ini-
tialization for the outdoor transmitter manually. Press and hold ▼ button for 3 seconds. The
base station will scan the outdoor temperature.
4.1. Radio-controlled time reception
• The clock will now scan the DCF frequency signal and the DCF symbol will be flashing. When
the time code is received successfully after 3-7 minutes, the radio-controlled time and the DCF
symbol are displayed steadily in the display.
• Caution: During the DCF time reception period, backlight turns off and no outdoor temperature
will be transmitted.
• If there is no reception possible, manual initialization can be helpful.
• Press the WAVE button.
• The DCF symbol will be flashing.
• Interrupt the reception by pressing the WAVE button again. The DCF symbol disappears.
• The DCF reception always take place at 1:00 o'clock in the morning until 5.00 o'clock. If the
reception is not successfully received at 5:00 o'clock, further attempts will be made again at
1:00 clock in the morning.
• If the clock cannot detect the DCF-signal (for example due to disturbances, transmitting dis-
tance, etc.), the time can be set manually. The DCF symbol disappears and the clock will then
work as a normal quartz clock. (see: Manual setting of the clock and calendar).
21