Industry Canada; Zertifizierung Profinet Mit Ethernet-Apl; Externe Normen Und Richtlinien - Endress+Hauser Micropilot FMR60B PROFINET mit Ethernet-APL Technische Information

Micropilot FMR60B PROFINET mit Ethernet-APL

Industry Canada

Zertifizierung PROFINET mit
Ethernet-APL
Externe Normen und Richtli-
nien
Endress+Hauser
The devices are compliant with the FCC Code of Federal Regulations, CFR 47, Part 15, Sections
15.205, 15.207, 15.209.
In addition, the devices with following listed antennas are compliant with Section 15.256:
• Encapsulated antenna, PVDF, 40 mm (1,5 in)
• Drip-off antenna 50 mm (2 in)
• Integrated antenna, PEEK, 20 mm (0,75 in)
• Integrated antenna, PEEK, 40 mm (1,5 in)
For these LPR (Level Probe Radar) applications the devices must be professionally installed in a
downward operating position. In addition, the devices are not allowed to be mounted in a zone
of 4 km (2,49 mi) around RAS stations and within a radius of 40 km (24,86 mi) around RAS
stations the maxium operation height of devices is 15 m (49 ft) above ground.
Canada CNR-Gen Section 7.1.3
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) This device may not interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d' I ndustrie Canada applicables aux appareils radio exempts
de licence. L' e xploitation est autorisée aux deux conditions suivantes : (1) l' a ppareil ne doit pas pro-
duire de brouillage, et (2) l' u tilisateur de l' a ppareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d' e n compromettre le fonctionnement.
[Any] changes or modifications not expressly approved by the party responsible for compliance could
void the user' s authority to operate the equipment.
• The installation of the LPR/TLPR device shall be done by trained installers, in strict compliance
with the manufacturer's instructions.
• The use of this device is on a "no-interference, no-protection" basis. That is, the user shall accept
operations of high-powered radar in the same frequency band which may interfere with or
damage this device. However, devices found to interfere with primary licensing operations will be
required to be removed at the user's expense.
• This device shall be installed and operated in a completely enclosed container to prevent RF emis-
sions, which can otherwise interfere with aeronautical navigation.
• The installer/user of this device shall ensure that it is at least 10 km from the Dominion Astrophy-
sical Radio Observatory (DRAO) near Penticton, British Columbia. The coordinates of the DRAO are
latitude 49°19ʹ15ʹʹ N and longitude 119°37ʹ12ʹʹ W. For devices not meeting this 10 km separation
(e.g., those in the Okanagan Valley, British Columbia,) the installer/user must coordinate with,
and obtain the written concurrence of, the Director of the DRAO before the equipment can be
installed or operated. The Director of the DRAO may be contacted at 250-497-2300 (tel.) or
250-497-2355 (fax). (Alternatively, the Manager, Regulatory Standards Industry Canada, may be
contacted.)
• The Model FMR60B fulfills the requirements for use as LPR (Level Probe Radar).
• The Model FMR60BT is a submodel of the FMR60B that fullfills the requirements for use as
TLPR (Tank Level Probe Radar).
PROFINET mit Ethernet-APL Schnittstelle
Das Gerät ist von der PNO (PROFIBUS Nutzerorganisation e. V.) zertifiziert und registriert. Das Gerät
erfüllt alle Anforderungen der folgenden Spezifikationen:
• Zertifiziert gemäß:
• Test Spezifikation für PROFINET devices
• PROFINET Security Level – Netload Class
• Das Gerät kann auch mit zertifizierten Geräten anderer Hersteller betrieben werden (Interoperabi-
lität)
• EN 60529
Schutzarten durch Gehäuse (IP-Code)
• EN 61010-1
Sicherheitsbestimmungen für elektrische Mess-, Steuer-, Regel- und Laborgeräte
• IEC/EN 61326
Emission gemäß Anforderungen für Klasse A; Elektromagnetische Verträglichkeit (EMV-Anforde-
rungen)
• NAMUR NE 21
Elektromagnetische Verträglichkeit von Betriebsmitteln der Prozess- und Labortechnik
57