Manual Initiation Of A Lorawan ® Transmission; Battery Life; Registration - WIKA NETRIS 3 Betriebsanleitung

5. Commissioning, operation
5.5 Manual initiation of a LoRaWAN
When activated, if it is integrated into a LoRa
unit can trigger a manual data transmission.
Move the activation magnet over the reed switch to confirm activation.
LED lights up red approx. 1 s. After successful activation, the LED lights up
green for 5 s.

5.6 Battery life

Since the battery life is influenced by many factors, such as the measurement and sending
rate, the spread factor, and the ambient and process temperatures, this value is only an
approximation. The calculation of the approximate value is based on a constant ambient
temperature of 20 °C [68 °F] is assumed.
The battery life depends very strongly on how often the instrument carries out a
measurement using the connected measuring instrument and then transmits or sends this
value via LoRaWAN. Therefore, in order to keep the battery operational for up to 10 years,
an hourly measurement and transmission should not be exceeded.

5.7 Registration

For the IIoT connection, all relevant data for registration, commissioning and maintenance,
as well as an interface specification for further processing of the data are provided (see
chapter 1 „General information" "Additional documentation").
The deployment package includes the following registration information:
DevEUI (64-bit end device, unique identifier)
■
AppEUI (64-bit unique application identifier)
■
AppKey (128-bit key)
■
Interface specification (→ see special documentation "LPWAN communication protocol"
■
of the corresponding WIKA measuring instrument on the WIKA website).
Payload description
With a customer-specific integration, the payload interpretation must be carried out by the
customer (see special documentation "LPWAN communication protocol" for the particular
WIKA measuring instrument on the WIKA website).
WIKA operating instructions, model NETRIS
®
transmission
®
network, the WIKA model NETRIS
®
3
®
3 radio
EN
21