WÜRGES HV-Serie Montage- Und Betriebsanleitung Seite 77

HF 6000 min -1 , 200 Hz, 3000 min
Motor Reduced Fore
HF 2 880 N
HF 6/4 1525 N
HF 6/8 380 N
HF 8 1525 N
HF 15 2400 N
After the centrifugal force has been set, the motor shaft, in the case of motors
with ball bearings, must be checked for ease of movement. If the shaft is stiff,
you should hit the last tightened screw, lightly with a mallet to loosen the tension
of the ball bearings.
Maximum tightening torques for the screws at the shaft end
HV 0,4/2 M5 4 Nm
HV 1 M5 4 Nm
HV 2 M 8 15 Nm
Ab HV 6 M10 20 Nm
-1 200 Hz
77