Residual Risks - Scheppach PSFA26 Original Bedienungsanleitung

• Do not operate this product if there is anyone in the
pool.
• This product may only be used in connection with
a degradable pool. Do not use it for built-in pools.
A storable pool can be completely dismantled and
stored over winter and then set up again in the sum-
mer.
• In order to prevent the risk of an accident, never en-
ter the pool if the suction device is loose, broken,
kinked, cracked, damaged or missing. Replace the
loose, broken, kinked, cracked, damaged or missing
suction devices immediately.
• Never play or swim in the vicinity of the suction
device. Your body or hair could be sucked in and
this could cause permanent injuries or cause you to
drown.
• In order the prevent damage to the system and the
risk of injury, always switch the pump off before
changing the position of the filter valve.
• Never operate this product above the maximum
working pressure which is specified on the filter con-
tainer.
• Dangerous pressure. An unauthorised or improper
attachment of the filter container cover can cause
the cover to shoot up due to the pressure which can
cause serious injury, property damage or death.
• This product may only be used for the purpose de-
scribed in the operating manual.
Electrical safety instructions
• When operating the product, the power plug must
be freely accessible after installation.
• Before you put your new pool filter system into oper-
ation, have it professionally checked:
- Earthing, connection of the neutral line and resid-
ual current circuit breaker must comply with the
safety regulations of the power supply companies
and function properly,
- Protect the electrical plug connections from mois-
ture.
- If there is a risk of flooding, fit the plug connec-
tions in the flood-proof area.
• Ensure that the mains voltage corresponds to the
specifications on the type plate.
• Carry out the electrical installation in accordance
with the national regulations.
• Only connect the product to a socket with a residual
current circuit breaker (FI switch) with a rated resid-
ual triggering current of up to 30 mA; Fuse at least
6 amps.
24 | GB
• Before each use, always check the product, cable
and plug for damages. Defective cables must not be
repaired but replaced with a new ones.
Have product damages repaired by a specialist.
• If the connection cable for the product is damaged
then it must be replaced by the manufacturer or
their customer services personnel or by a similarly
qualified person, in order to avoid hazards.
• Do not use the cable to pull the plug out of the out-
let.
• Protect the cable from heat, oil and sharp edges.
• Do not carry or attach the product by the cable.
• Use only extension cables that are splash-proof
and intended for outdoor use. Always unroll a ca-
ble drum completely before use. Check the cable for
damage.
• Pull out the mains plug before all work on the prod-
uct, in work breaks and when not in use.
• Mains connection cables shall not have a smaller
cross-section than rubber hose lines with the desig-
nation H05RN-F 3*0.75mm². The cable length must
be 10 m. The conductor core cross-section of the
extension cable must be at least 1.5 mm2.
Warning! This power tool generates an electromag-
netic field during operation. This field can impair active
or passive medical implants under certain conditions.
In order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the power tool.

6. Residual risks

The machine has been built according to the state-of-
the-art and the recognised technical safety require-
ments. However, individual residual risks can arise
during operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety infor-
mation" and the "Proper use" together with the oper-
ating manual as a whole are observed.
• Avoid accidental starting of the machine: the op-
erating button may not be pressed when inserting
the plug in an outlet. Use the tool attachment that
is recommended in this operating manual. This is
how to ensure that your machine provides optimum
www.scheppach.com