Package Contents; Description Of The Product - Num'axes CANICALM PREMIUM Gebrauchsanleitung

Package contents

- a collar equipped with short contact points
- a 3 Volt CR 2 lithium battery
- a pair of long contact points

Description of the product

Diagram 1
Setting screw for barking
detection sensitivity
Switching On the collar
- Remove the 4 screws from the battery cover with the supplied screwdriver.
- Remove the battery cover.
- Insert the 3 Volt CR 2 lithium battery paying attention to the polarity indicated on the battery housing
(See diagram 1). The tab is under the battery.
- A sound beep is emitted indicating the collar is ready to use.
If you do not hear any sound beep after inserting the battery, immediately remove it from its housing.
Check the polarity before inserting the battery once again.
- Replace the battery cover making sure the tab is in correct position (inside the battery housing) to
maintain water tightness.
- Retighten moderately the 4 screws.
Switching Off the collar
To switch Off the collar, remove the battery from its housing.
- a neon test lamp
- a screwdriver
- this user's manual
Battery
Battery tab
Gb - 12
Button to change
operating mode