N8WERK AFO-07D-R Bedienungsanleitung Seite 23

 
With the TOAST programme,
only the level of browning can be
set between 1 and 7, but not the
temperature.
4. If the hot air oven is going to be
preheated, touch the fi eld
The device switches on. Once the set
temperature has been reached, a beep is
heard and "Add food" is displayed.
5. Open the door (5) and slide the
accessory with the food onto the rails (7)
or insert the rotating spit (9) (see the
"Accessories" chapter).
6. Close the door. The device automatically
resumes the cooking process.
○ If the hot air oven is NOT going to be
preheated, insert the accessory into
the cooking chamber (4) and start the
cooking process with the fi eld
○ If the rotating spit is being used, touch
the fi eld (27) to switch on the
rotation.
○ The remaining cooking time appears on
the cooking time display (23). Once this
has elapsed, a beep is heard and "END"
is shown. The fan continues to run for a
few minutes.
○ If the cooking process is to be paused to
turn the food, for example, open the door.
The cooking process is resumed after
the door is closed.
○ To switch off the device prematurely,
touch the fi eld
7. Touch the fi eld
control panel.
8. Open the door, remove the accessory
and place it down on a heat-resistant
surface.
9. Allow the device and accessory to cool
down and then clean them (see the
"Cleaning and Maintenance" chapter).
(22).
(21).
.
to switch off the
DUAL COOK
With the DUAL COOK function, two
programmes or presettings are
automatically run through one after the
other (see the "Functions" chapter – "DUAL
COOK").
1. Touch the fi eld
the control panel (1). The programme
display (17) AIR FRY fl ashes.
2. Touch the fi eld DUAL COOK (15).
The programme displays (17) AIR FRY,
BAKE, BROIL, ROAST and WARM
remain switched on. The rest go out.
3. Use the fi elds
to select the programme that should be
started fi rst and if necessary adjust the
temperature and cooking time using the
buttons (18) and then + / – (see the
"Functions" chapter).
 
To cancel the DUAL COOK function
and display the full control panel,
touch the fi eld
4. Confi rm the presetting with the fi eld
. After this, only the four remaining
programme displays remain lit.
5. Repeat step 3 for the programme which
should then follow.
6. Continue in the same way as you would
for conventional use (see previous
section, from step 4).
 
The temperature and cooking
time for the programme which is
currently running are displayed.
(20) to activate
(19) or + / – (16, 25)
(21).
EN
23