Specifications - Makita TD091D Betriebsanleitung

ENGLISH
(Original instructions)
1 Button
2 Battery cartridge
3 Switch trigger
4 Lamp
5 Reversing switch lever
6 Bit
7 Sleeve
8 Bit-piece

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
Overall length
Rated voltage
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from
country to country.
• Weight, with battery cartridge, according to EPTA-Pro-
cedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
CORDLESS IMPACT DRIVER SAFETY
WARNINGS
1. Hold power tool by insulated gripping surfaces,
when performing an operation where the fas-
tener may contact hidden wiring. Fasteners con-
tacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator
an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
Explanation of general view
9 Standard bolt
10 Fastening torque
11 Fastening time
12 Proper fastening torque
13 High tensile bolt
14 Limit mark
15 Rear cover
16 Screws
Model
Machine screw
Standard bolt
High tensile bolt
–1
)
Net weight
4. Wear ear protectors.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product.
MISUSE or failure to follow the safety rules stated in
ENE033-1
this instruction manual may cause serious personal
injury.
IMPORTANT SAFETY INSTRUCTIONS
GEA010-1
FOR BATTERY CARTRIDGE
1. Before using battery cartridge, read all instruc-
tions and cautionary markings on (1) battery
charger, (2) battery, and (3) product using bat-
tery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively
GEB054-1
shorter, stop operating immediately. It may
result in a risk of overheating, possible burns
and even an explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any conduc-
tive material.
(2) Avoid storing battery cartridge in a con-
tainer with other metal objects such as nails,
coins, etc.
17 Spring
18 Arm
19 Recessed part
20 Carbon brush cap
21 Lead wire
22 Spacer
23 Hole
TD091D
4 mm – 8 mm
5 mm – 12 mm
5 mm – 10 mm
0 – 2,400
0 – 3,000
134 mm
0.87 kg
D.C.10.8 V
ENC009-1
5