Maintenance And Care - Forch 5350 4400 Bedienungsanleitung

Maintenance and Care

■
Before starting the maintenance work always disconnect the device from the com-
pressed air supply
■
To clean the pneumatic ratchet use benzine or appropriate cleaner used for assembling
■ Only use the spare parts recommended by FÖRCH
■
Replace damaged construction and wear parts as e.g. bearings, O-rings, etc.
■
Use of non-approved replacement parts will void the warranty, service, compensation
and liability claims against FÖRCH
■ Proper disposal according to the guidelines for environmental protection have to be
observed
Lubrication
■ FÖRCH recommends the installation of a maintenance unit with lubricator at the com-
pressed air pipe system before the pneumatically driven hand tools
■
In case of manual lubrication, apply 1 – 2 drops of pneumatic oil daily to the air inlet of
the ratchet
Disposal
■
The disposal must comply with the legislation of the respective country
Technical Data :
Model:
Max. torque
Type of hammer mechanism:
Drive:
Operating pressure:
Air consumption:
Sound pressure LpA:
Sound power LpW:
Vibration:
Turns:
Weight:
Recommended hose diameter:
5350 4400
122 Nm
Pin hammer
1/2"
6,2 bar
113 l/min
91 dB(A)
98 dB(A)
4,53 m/s²
600 U/min
1,28 kg
10 mm