Environmental Protection; Troubleshooting Table; Declaration Of Conformity - Kress KG367E.9 Bedienungsanleitung

could occur from electrical shock or body
contact with moving chain.
Cutting edges on chain are sharp. Use protective
gloves when handling chain.
Keep chain sharp. Your saw will cut faster and more
safely. A dull chain will cause undue sprocket, Guide Bar,
chain, and motor wear. If you must force chain into wood
and cutting creates only sawdust with few large chips,
chain is dull.
LUBRICATE SPROCKET
WARNING: Wear heavy duty gloves when
performing any maintenance or service to
this tool. Always remove the battery pack
before performing any service or maintenance
on this tool.
NOTE: It is not necessary to remove the chain or bar
when lubricating the guide bar sprocket.
1. Clean the bar and sprocket
2. Using a grease gun, insert the tip of the gun into the
lubrication hole and inject grease until it appears at
the outside edge of the sprocket tip. (See Fig. U)
3. To rotate the sprocket pull the chain by hand until
the ungreased side of the sprocket is in line with the
grease hole. Repeat the lubrication procedure.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage
of tool and battery is 0 °C-45 °C
16 The recommended ambient te.mperature range for the
charging system during charging is 0 °C-40 °C.
EN
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
TROUBLESHOOTING
TABLE
The following table gives checks and actions that you
can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your
service agent.
WARNING: Switch off and remove plug from
power source before investigating fault.
Symptom Possible Cause
Chainsaw fails to Low battery
operate charge.
Chain brake not
in the proper
position.
Chainsaw Over heating
operates Applying too
intermittently much pressure
while cutting.
Loose connection.
Internal wiring
defective.
On/Off switch
defective.
Dry chain No oil in reservoir.
Vent in oil filler
cap clogged.
Oil passage
clogged.
Kickback Brake/ Brake does not
Run stop chain
Down Brake
Chain/chain bar No oil in reservoir.
over-heats. Vent in oil filler
cap clogged.
Oil passage
clogged.
Chain is over
tensioned.
Dull chain.
Chainsaw rips, Chain tension too
vibrates, does loose.
not Dull chain.
saw properly. Chain worn out.
Chain teeth are
facing in the
wrong direction.
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product
Description Battery-powered chainsaw
Type KG367E .9 (3 - designation of machinery,
Remedy
Charge both
the battery
packs.
Check to see
if the chain
brake is in
position
. Refer to
CHAIN BRAKE
for details.
Place the
machine in a
cool, ventilated
place to cool it
down.
Applying
relatively less
pressure while
cutting.
Contact
service agent.
Contact
service agent.
Contact
service agent.
Refill oil.
Clean cap.
Clean oil
passage
outlet.
Contact
service agent
Refill oil.
Clean cap.
Clean oil
passage
outlet.
Adjust chain
tension.
Sharpen chain
or replace.
Adjust chain
tension.
Sharpen chain
or replace.
Replace chain.
Reassemble
with chain
in correct
direction.