Component List; Technical Data; Accessories; Noise Information - Kress KG367E.9 Bedienungsanleitung

COMPONENT LIST

1. CHAIN
2. GUIDE BAR
3. CHAIN BRAKE LEVER (HAND GUARD)
4. FRONT HANDLE
5. BATTERY PACK RELEASE BUTTON*
6. LOCK-OUT BUTTON
7. REAR HANDLE
8. REAR HAND GUARD
9. ON/OFF SWITCH
10. OIL LEVEL WINDOW
11. OIL FILLER CAP
12. BUMPER SPIKE
13. CHAIN TENSIONING KNOB
14. CHAIN DIRECTION SYMBOL
15. OIL OUTLET
16. BAR LOCATING TABS
17. FASTENING BAR BOLT
18. BAR PAD
12
19. DRIVE SPROCKET
EN
20. BAR AND CHAIN STORAGE/ TRANSPOR-
TATION COVER (SHEATH)
21. BAR TENSIONING PLATE (SEE FIG. A2)
* Not all the accessories illustrated or de-
scribed are included in standard delivery.

TECHNICAL DATA

Type KG367E.9 (3 - designation of machinery,
representative of Chainsaw)
Voltage
Bar length
Chain speed
Oil tank capacity
Chain pitch
Number of chain
drive links
Chain gauge
Adaptive Chain type
Adaptive Bar type
Machine Weight
KG367E.9
60 V Max. **
35 cm
22 m/s
190 ml
0.95 cm
52
1.1 mm
Oregon/90PX052G
Oregon/144MLEA041
4.3 kg
**Voltage measured without workload. Initial battery
voltage reaches maximum of 60 volts. Nominal voltage
is 54 volts.

ACCESSORIES

Chain (KA2624)
Bar (KA2602)
Transportation Cover
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice.

NOISE INFORMATION

A weighted sound pressure
K
pA
A weighted sound power
K
pA
Wear ear protection.

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission value:
Uncertainty
The declared vibration total value and the declared noise
emission value have been measured in accordance with
a standard test method and may be used for comparing
one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways in which
the tool is used especially what kind of workpiece is
processed dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
1
1
1
L = 92.5 dB(A)
pA
3 dB(A)
L = 99.3 dB(A)
wA
3 dB(A)
a = 4.4 m/s
2
h
K = 1.5 m/s²