Assembly&Operation - Kress KG155E Bedienungsanleitung

Helping to minimise your vibration exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
FOR BRUSH CUTTER:
NOISE INFORMATION
A weighted sound pressure
K
pA
A weighted sound power
K
wA
Wear ear protection
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission value:
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY:
Assembling the Trimmer Shaft(See Fig. A)
Insert the screw into the hole, then tighten the
locking knob
Assembling the Auxiliary Handle and
Safety-stop Handle(See Fig. B1, B2)
Assembling the Safety Guard(See Fig. C)
Insert the metal bracket into the slot on the safety
guard, then secure the guard in place using the
screw and hex key.
Assembling the Shoulder Strap(See Fig. D)
Installing and Removing the Battery
Pack(See Fig. E1, E2)
NOTE:
• This machine will only run when 2 batteries are
L = 72.53dB(A)
pA
3dB(A)
L = 92.53dB(A)
wA
3dB(A)
= 2.673m/
a s
2
h
Uncertainty K = 1.5m/s²
installed. It is recommended to use the same two
batteries and charge the two batteries at the same
time.
• When two batteries are used with different amp
hours or charge level, the machine will run to the
lowest common denominator.
* It is recommended that using 4.0Ah or above
battery pack for better performance and longer run
time.
Checking the battery charge condition(See
Fig. E3)
NOTE: Fig. E3 only applies for the battery pack
with battery indicator light.
Charging the battery pack(See Fig. E4)
NOTE:
The batteries are shipped uncharged. Each
•
battery must be fully charged before the first use.
Always fully charge the two batteries at same
•
time. More details can be found in charger's
manual.
Battery power indicator on the machine
(See Fig. E5)
Before starting or after use, press the button beside
the power indicator light on the machine to check
the battery capacity. During operation, the battery
capacity will be indicated automatically by the
battery power indicator.
The indicator constantly senses and displays the
battery condition as follows.
For the machine with 2 battery packs with different
power, the power indicator light displays the battery
condition with the lower one of the two batteries.
Battery power
indicator status
Five green lights The two batteries are in a
( ) are highly charged condition.
illuminated.
Two, three or four The two batteries have a
green lights are remaining charge. The more
illuminated. lights are illuminated, the
more battery capacity.
Only one green light At least one battery is
( ) is almost depleted and needs
illuminated. to be charged.
No light is At least one battery is not
illuminated. fully installed or battery may
be defective.
Only one light is At least one battery is
flashing twice per over discharged (please
cycle. refer to the battery charge
condition), please recharge
the two batteries at once
before use again or storage.
Battery condition
17
EN