Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
between these models
*** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
SUGGESTED BATTERIES
AND CHARGERS
Category
20V Battery
20V Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure
K
pA
A weighted sound power
12
K
wA
EN
Wear ear protection
VIBRATION INFORMATION
Typical weighted vibration
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
Model
Capacity
KAB04
4.0Ah
KAC04
4.0A
L
: 78.7dB(A)
pA
3.0dB(A)
L
:91.97dB(A)
wA
1.44dB(A)
a
<1.5m/s
2
h
uncertainty K=1.5m/s²
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Avoid using tools in temperatures of 10
Plan your work schedule to spread any high vibration
tool use across a number of days.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the instruction
book carefully.
ASSEMBLY:
Assembling the Auxiliary Handle(See Fig.
A1,A2,A3)
Removing the tube plug(See Fig.B1)
NOTE:Before assembling the pole, Please remove the
tube plug.
Assembling the pole(See Fig.B2)
Assembling the Safety Guard. (See Fig. C)
Insert the metal bracket into the slot on the safety
guard, then secure the guard in place using the screw
and hex key.
Installing and Removing the Battery
Pack(See Fig. D1, D2)
NOTE:
• This machine will only run when 2 batteries are
installed. It is recommended to use the same two
batteries and charge the two batteries at the same
time.
• When two batteries are used with different amp
hours or charge level, the machine will run to the
lowest common denominator.
• It is recommended that using 4.0Ah or above battery
pack for better performance and longer run time.
Checking the battery charge condition(See
Fig. D3)
NOTE: Fig. D3 only applies for the battery pack with
battery indicator light.
Charging the battery pack(See Fig. D4)
NOTE:
• The batteries are shipped uncharged. Each battery
must be fully charged before the first use.
• Always fully charge the two batteries at same time.
C or less
o
Werbung
Inhaltsverzeichnis
Fehlerbehebung
