Technical Data; Vibration Information; Specifications - Kress KG155E Bedienungsanleitung

8. SAFETY-STOP HANDLE
9. LOCKING KNOB
10. LOWER SHAFT
11. SAFETY GUARD
12. LINE CUTTER
13. SKIRT
14. TRIMMER HEAD (BUMP HEAD)
15. RELEASE TAB
16. BRUSH-CUTTER BLADE
17. WASHER
18. BLADE HOUSING
19. LOCK-NUT
20. SHOULDER STRAP
21. WRENCH
22. HEX KEY
23. POLE HEDGE TRIMMER ATTACHMENT*
24. POLE SAW ATTACHMENT *
25. EDGER ATTACHMENT *
* Not all the accessories illustrated or
16
described are included in standard delivery.
EN

TECHNICAL DATA

Type Designation: KG155E KG155E.X
(1-designation of machinery, representative of
Cordless Grass Trimmer)
Voltage
No Load Speed
Cutting Diameter
for grass trimmer
Cutting diameter
for brush cutter
blade
Line Diameter
Line length
Machine weight
(bare tool)
** X=1-999,A-Z,M1-M9 they are only used for
different customers, there are no safe relevant
changes between these models
*** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
KG155E
KG155E.X **
40V MAX (2x20V MAX) ***
6000/min
38cm
25cm
Recommended 2.4mm twist line
Recommended 4m
(Dual-Exit)
4.1 kg
Category Model
20V Battery KAB04
20V Charger KAC04
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
FOR GRASS TRIMMER:
NOISE INFORMATION
A weighted sound pressure
K
pA
A weighted sound power
K
wA
Wear ear protection

VIBRATION INFORMATION

Typical weighted vibration
Uncertainty
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the
tool is used dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
Using the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Capacity
4.0Ah
4.0A
L = 81.5dB(A)
pA
1.93dB(A)
L = 94.4dB(A)
wA
1.93dB(A)
a =2.822m/s
2
h
K = 1.5m/s²