Mounting Accessories - Ferm CDM1074 Originalbetriebsanleitung

Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
• The tool is suitable for use as a screwdriver
and drill. Any other application is specifically
excluded.

3. MOuntIng aCCESSORIES

Inserting and removing bits
Fig. 1
In addition to screwdriver bits with a hexagonal
shaft, this tool can also accommodate drill bits
with a hexagonal shaft.
Always use short screwdriver bits in
combination with the magnetic bit holder.
The 50 mm screwdriver bits can be used
without the magnetic bit holder.
• Pull back the locking sleeve (2) and insert the
magnetic bit holder or 50mm screwdriver bit.
• Release the locking sleeve.
• To remove, pull back the locking sleeve and
remove the bit or magnetic bit holder.
4. OPERatIOn
Always follow the safety notes and the
relevant safety code.
Hold the appliance firmly and press the
screwdriver steadily onto the work piece. Do not
overload the appliance. Only use bits with no
visible wear. Worn bits will have a bad effect on
the functioning of the appliance.
adjusting the torque
Fig. 1
The appliance has 17 different torque settings
with which to set the power for driving and
removing screws.
• Set the torque settings ring (3) to the desired
position. The available torque settings are
indicated on the settings ring by the numbers 1
to 15 and by dots between the figures to
define intermediate settings. And a setting for
drilling indicated by the drill icon (17 in total).
6
• You should preferably choose a setting as low
as possible when using the screwdriver. Select
a higher setting if the motor slips.
Driving and removing screws
Fig. 1
• Set the direction switch (9) to position '' in
order to drive screws.
• Set the direction switch (9) to position '' in
order to remove screws.
Ensure that the direction switch (9) is
always set to '' during drilling and the
drill symbol selected on the torque
settings ring.
Switching the device on and off
Fig. 1
• Depress the on/off switch (8). It regulates the
speed of the appliance by transmitting power
to the switch.
• Release the on/off switch (8) to halt the drill
chuck immediately, it will no longer run on.
• Move the direction reversing switch (9) to the
centre in order to lock the appliance in its
disabled state.
The tool will turn at its slowest speed when the
switch is depressed lightly. The tool will turn at its
fastest speed when the trigger is fully depressed.
Only lay down the appliance when it has stopped
running completely. Do not place it on a dusty
surface as particles of dust could get into the
mechanism.
LED work light
Fig. 2
• Press the LED work light switch (11) once to
switch the LED work light on.
• Press the LED work light switch (11) again to
switch the LED work light off.
Charging the battery
• Only use the battery charger in a temperature
range between + 5 °C to + 40 ºC.
• Only use the battery charger in dry, ventilated
rooms.
One advantage of using Lithium-Ion batteries is
that, until the battery is almost empty, hardly any
power fading is noticeable. The machine can be
used until you start noticing that the power of the