Hella Gutmann SEG V Bedienungsanleitung Seite 118

8. | Working with the Device
Proceed as follows to align the SEG V to the vehicle:
1. Position the SEG V at a distance between 30 and 70 cm in front of the headlights.
2. Switch on the laser sight.
Alternatively you can use the optical sight (black line in the right area of the sight).
The laser is activated for approx. 30 s.
3. Loosen the hand wheel of the column locking mechanism (12).
By loosening the hand wheel, you can turn the optic housing.
4. Use the laser sight or the optical sight to align the optic housing in a way that the laser line 2 touches points at the
same height, symmetrical to the geometric center line (fig. 6).
5. Tighten the hand wheel of the column locking mechanism (fig. 6), without changing the alignment.
6. Move the SEG V in front of the headlight to be tested.
The distance from the front edge of the optic housing to the headlight shall be between 30 and 70 cm (see fig. 6).
7. Fasten the optic housing to the center of the headlight.
Deviations in height and side to the prevailing light source shall be max. 3 cm.
118
Hella Gutmann
SEG V