Beemoo ROTATE Bedienungsanleitung Seite 19

Installing the seat in the forward facing position, from 76 cm to 105 cm
2a. Press the button (8) and turn the seat.
2b. Turn the seat until it locks into the loading position ready for the child to be placed in it (perpendicular to the
forward facing position).
2d. Pressthe button(8) again to place the seat in the forward facing position. It is Important to check that the seat
is firmly locked into place.
Installing the seat in the forward facing position, from 100 cm to 145 cm
Storing the safety harness away
2e. Once the child has reached a height of 100 cm, the harness should be stored away and the child should be secured
with the vehicle safety belt.
To store the harness away it needs to be fully loosen first, lift the cover and store the buckle parts in the compartment.
Then put the cover back on the seat. Hiding the shoulder pad in the rear side of the upholstery.
2f. IMPORTANT! The support leg is not needed for the 100 – 145 cm configuration, raise it so that it does not touch the
floor of the vehicle.
2g. With the child placed in the seat put the vehicle seat belt on passing it through the guide (15). Fasten the vehicle seat
belt buckle and make sure the belt is not too loose.
Gently pulling the diagonal part of the belt before placing the belt over the child's chest.
3. STRAPPING THE CHILD INTO THE SEAT
This child restraint system has a loading position making it easy to place the child in the seat and adjust the
straps to fit correctly.
3a. Turn the seat to the loading position (2b) and open the harness (5). Move the harness straps to the sides to place
the child in the seat.
3b. Place the straps over the child and fasten the buckle.
18