Using The Beemoo Rotate In The Rear Facing Or Forward Facing Position - Beemoo ROTATE Bedienungsanleitung

1d. Move the seat backwards pressing the backrest against the vehicle seat. Then pull the safety seat towards you to
check that it is securely locked in place.
1e. Press the button(13)to adjust the height of the supportleg(12) until it is firmly in contact with the floor. It should not
be on top of any type of compartment. At this point make sure that the support leg is at 90° to the safety seat.
The visual ISOFIX indicators show whether the connector is open or closed. It may be that the connector is closed but not
locked into the ISOFIX anchor. Please check that all the connectors are correctly locked into the vehicle anchor points by
pulling the seat once it is installed.
To detach the seat follow the same steps in reverse.
1f. Move the button (10) to open the connector and release it from the anchor point.

2. USING THE BEEMOO ROTATE IN THE REAR FACING OR FORWARD FACING POSITION

Installing the seat in the rear facing position, from 40 cm 105 cm
2a. Press the button (8) and turn the seat.
2b. Turn the seat until it locks into the loading position ready for the child to be placed in it (perpendicular to the
forward facing position).
2c. Press the button(8)again to place the seat in the rear facing position.
It is important to check that the seat is firmly locked into place.
Make sure the seat is fully reclined before rotating to rear facing position.
WARNING! Never use on a vehicle seat fitted with an AIRBAG.
17