Bosch 0 607 452 603 Anleitung Seite 17

Noise/Vibration Information
Measured sound values determined in accordance with
EN ISO 15744.
Measured vibration values determined in accordance
with EN 28662 and EN ISO 8662.
Typically the A-weighted noise levels of the tool are:
sound pressure level 80 dB(A); sound power level
93 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
The hand-arm acceleration is typically below 2.5 m/s
Uncertainty K=1.2 m/s
Technical Data
Pneumatic Angle Nutrunner with Shut-off Mechanism
Article number
No-load speed n
0
Output power
Max. torque for hard/soft screwdriving
application according to ISO 5393
Max. screw dia.
Rotational direction
Tool holder
Lever start
Shut-off clutch
Rated pressure
Connecting thread
Inside hose diameter
Air consumption under load
Weight according to
EPTA-Procedure 01/2003
* When the tool is used in the upper torque range, it must be supported by using a reaction bar.
Assembly
Suspension and clamping device
If you wish to operate the pneumatic tool in a
suspension or clamping device, make sure
that the pneumatic tool is first mounted in the
device before you connect it to the air supply.
In this way you avoid starting the tool accidentally.
You can use the clamping area 10 to mount the pneu-
matic tool in a clamping device. If possible, use the
3 609 929 A78 • 8.8.06
2
.
Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or stan-
dardization documents: EN 792, according to the
provisions of the directive 98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
2
.
03.08.2006, Robert BoschGmbH, Power Tools Division
D-70745 Leinfelden Echterdingen
0 607 452 603
rpm 570
W 550
Hp 0.74
Nm 16–40*
ft-lbs 11.8–29.5*
mm M6
3/8"
bar 6.3
psi
G 1/4"
mm
in 3/8"
l/s
cfm 31.8
kg 1.50
lbs 3.30
entire clamping area. The smaller the clamping area,
the stronger the clamping force.
Do not overstrain the clamping area and make sure that
the clamping device holds the tool securely and tightly.
With the hanging hoop 4, the pneumatic tool can be
attached to a suspension device.
Regularly check the condition of the hanging
hoop and the hook of the suspension device.
Dr. Eckerhard Strötgen
Head of Product
Certification
0 607 452 604
400
550
0.74
16–56*
11.8–41.3*
M8
3/8"
6.3
91 91
G 1/4"
10 10
3/8"
15 15
31.8
1.50
3.30
0 607 452 605
320
550
0.74
20–68*
14.7–50.1*
M8
3/8"
6.3
91
G 1/4"
10
3/8"
15
31.8
1.50
3.30
English | 17