Transport - Dantherm Simplify Kurzanleitung Zur Installation

Transport

Installation
10
The lithium batteries contained are subject to the requirements of the dangerous goods
regulations (class 9 dangerous goods, lithium content > 1.0 g, < 5.0 g). When shipping via
third parties (e.g. air transport or freight forwarding), special requirements for packaging and
marking must be observed. In this case, a dangerous goods expert must be consulted when
preparing the package for shipping.
Component
Control unit
Sensor box
Fully charge the Simplify Control Unit for 4 hours when putting it into operation for the first
time or after prolonged storage (≥ 6 months). If you notice that the Simplify Control Unit has a
damaged battery, send the Simplify Control Unit to Dantherm A/S for battery replacement.
The battery provided with the Simplify Sensor Box is not rechargeable and must be replaced
once discharged. To provide for a service life of 5 years, use a 9 V metal lithium battery with at
least 1200 mAh. For replacement of the battery in the Simplify Sensor Box, please refer to the
video under:
https://www.youtube.com/watch?v=3drKseAWyKs
NOTICE
The product warranty is voided if a battery in the Simplify Control Unit is re-
placed by anyone other than Dantherm A/S.
The start-up is carried out with the Simplify App „Simplify Climate Solutions" for smartphones
and tablets. If you have not installed it yet, download it from the respective App Store and in-
stall the app (Fig. 2).
1. Open the Simplify App and have the Simplify components ready to scan the affixed QR
codes (Fig. 3).
ð If the list is empty, you will be prompted to scan directly. For each additional compon-
ent, press "ADD" or "+".
2. Scan the QR code on the Simplify Control Unit and name the Simplify Control Unit so that
the results can be clearly assigned to this project later.
INFORMATION
If a previous project has not been archived in the Simplify App, the previous name is displayed
instead of "Archived".
• To store the previous project, press "ARCHIVE".
3. Open the "SENSORS" tab. Scan and name each Simplify Relay Box, each Simplify Sensor
Box and, if applicable, other Simplify components.
4. If you are using a Dantherm CDT MKII and MKIII condensing dehumidifier with
Simplify Integration Box, scan the corresponding QR code on the unit.
Batteries contained
1 × 3.7 V lithium-ion battery
1 × CR2032 lithium button cell battery.
1 × 9 V metal lithium battery.
≥ 1200 mAh (for a service life of at least 5 years)