Siguro SGR-RV-L650B Bedienungsanleitung Seite 14

EN
Planned Cleaning
For effective use of the cleaning planner feature, the internal clock must be set accu-
rately.
Step 1: Set Clock
1. Long-press
in the internal clock.
2. Use the / buttons to set the hour to the correct current hour.
3. Then press ; the minute component of the current time will flash. Press  to
return to setting the hour component if needed.
4. Use the / buttons to set the minute component to the correct current minute.
5. Press
Note:
While not technically necessary for operation, we recommend setting the
clock to match the actual current time.
Step 2: Plan Cleaning
1. Press . The display will flash the hour component of the current time as set in
the internal clock.
2. Use the / buttons to set the hour to the correct current hour.
3. Then press ; the minute component of the current time will flash. Press  to
return to setting the hour component if needed.
4. Use the / buttons to set the minute component to the correct current minute.
5. Press
Note:
If you hear no chime, the cleaning plan was not set properly and will need
to be set again.
6. The vacuum will activate at the set time. There may be a delay of 15 to 30 seconds
after the set time before the vacuum actually begins cleaning; this is normal
behavior.
Cancelling Planned Cleaning
If you need to cancel your cleaning plan, there are two options:
1. Set planned cleaning time to "00:00"; no cleaning will occur with this setting.
Follow the procedure set out in "Step 2: Plan Cleaning" above.
2. Turn off the vacuum and set the main switch to 0 (off); this will automatically
cancel planned cleaning.
Wet Cleaning Attachment
This rear-mounted attachment allows the appliance to also wipe the floor it has just
vacuumed.
1. Remove the filler cap and fill the tank with clean water. Replace the cap and check
that water is not leaking anywhere. Wipe the wet cleaning attachment dry.
2. Rinse the rag in warm water, wring out by hand and mount on the wet cleaning
frame.
3. Turn the vacuum upside down. First remove the dustbin, then mount the wet
cleaning attachment. Make sure it is securely mounted.
. The display will flash the hour component of the current time as set
to confirm.
to confirm. A chime will sound to confirm the setting has been saved.
EN - 14