Use; Power On/Off; Standby Mode; Cleaning Mode Selection - Siguro Sgr-Rv-L650B Bedienungsanleitung

or reflective floor materials, and other adverse conditions. We thus recommend
blocking off areas where the vacuum might fall off a step or ledge with suitable
obstacles.

USE

Power On / Off
1. Set down the vacuum in the room to be cleaned. Make sure it has a full charge.
2. Set the main switch to the I (on) position.
3. Turn the appliance on by pressing
vacuum will turn on in automatic cleaning mode.
4. Once the space has been cleaned or if you need to stop cleaning, press
vacuum or on the remote. The vacuum will stop cleaning and go to standby
mode.
5. To power down completely, set the main switch to 0 (off).

Standby Mode

The vacuum automatically enters standby mode after 3 minutes of inactivity. The
button stops glowing. Press

Cleaning Mode Selection

The cleaning mode can only be changed using the remote control.
1. Edge Cleaning Mode
The edge cleaning mode allows for effective cleaning along walls, furniture edges, etc.
The vacuum will start out same as in automatic mode, but will slow down and then
keep hugging a wall or edge as soon as it detects one. The slower speed allows better
cleaning of such places. Once the vacuum detects an end to the edge it has been
following, it will return to automatic cleaning mode.
To turn on edge cleaning mode, press
This mode is also available together with automatic cleaning mode.
2. Thorough Cleaning Mode
Thorough mode improves the thoroughness of cleaning in a bordered space. Once ac-
tivated, the vacuum will move in a spiral, cleaning the space from the center outward.
This approach allows for maximum coverage and effectiveness.
To turn on thorough cleaning mode, press
3. Automatic Zigzag Cleaning Mode
In automatic mode, the vacuum combines various pathfinding algorithms to efficient-
ly cover the entire floor space.
Automatic mode is the default mode the vacuum starts in when powered on.
To turn on automatic cleaning mode, press
Note:
In some situations, the vacuum will switch to a different mode on its own,
usually in reaction to obstacles or other features of the room. This is nor-
mal behavior intended to improve the efficiency of the vacuum's cleaning
routine.
on the vacuum itself or
again to exit standby mode; the display will light up.
on the remote.
on the remote.
on the remote.
EN - 13
on the remote. The
on the
EN