Safety And Environment Instructions; Intended Use; General Safety - Küppersbusch FK2545.0i Bedienungsanweisung Mit Montageanweisungen

2

Safety and environment instructions

This section provides the safety
instructions necessary to prevent the
risk of injury and material damage.
Failure to observe these instructions will
invalidate all types of product warranty.

Intended use

WARNING:
Keep ventilation openings,
A
in the appliance enclosure or
in the built-instructure, clear
of obstruction.
WARNING:
Do not use mechanical
devices or other means
A
to accelerate the defrosting
process, other than those
recommended
manufacturer.
WARNING:
A
Do
refrigerant circuit.
WARNING:
Do
appliances inside the food
A
storage compartments of the
appliance, unless they are of
the type recommended by
the manufacturer.
This appliance is intended to be used
in household and similar applications
such as
– staff kitchen areas in shops, offices
and other working environments;
– farm houses and by clients in hotels,
motels and other residential type
environments;
– bed and breakfast type environments;
– catering and similar non-retail
applications.
by
not damage
not use electrical

General safety

This product should not be used
•
by persons with physical, sensory
and mental disabilities, without
sufficient knowledge and experience
or by children. The device can only
be used by such persons under
supervision and instruction of a
person responsible for their safety.
Children should not be allowed to
play with this device.
In case of malfunction, unplug the
•
device.
After unplugging, wait at least 5
•
minutes before plugging in again.
Unplug the product when not in use.
•
the Do not touch the plug with wet
•
hands! Do not pull the cable to plug
off, always hold the plug.
Do not plug in the refrigerator if the
•
the
socket is loose.
Unplug the product during
•
installation, maintenance, cleaning
and repair.
If the product will not be used for
•
a while, unplug the product and
remove any food inside.
Do not use the product when the
•
compartment with circuit cards
located on the upper back part of
the product (electrical card box
cover) (1) is open.
7
EN