General Information - iFactory3D One Pro Einrichtungsanleitung

V_97971.03

General Information

Read the instructions carefully. By using the machine, you confirm to
have read the assembly instructions as well as the safety, maintenance
and warranty advice!
Safety advice
Unintended use and wrong handling can lead to machine fault.
The machine can only be used or cleaned or maintained by instructed persons.
Intended use just includes 3D printing (additive manufacturing) of polymer parts with appropriate material (filament).
Outdoor use is not recommended. Use only at own risk.
Avoid contact between the device and any liquid.
Always pull the power plug when the machine is not in use or before cleaning/maintaining.
Power cable is not allowed to touch hot, moving or sharp objects.
Do not use the machine if:
The power plug/cable is damaged.
o
The device may have been damaged by a fall or for other reasons.
o
Do not open the electronics case, especially not the power supply unit.
The device must be used on a flat surface large enough to accommodate the entire machine.
This surface must be heat-resistant and vibration-proof.
Make sure that no flammable objects can come into contact with the device.
Careful!
Printhead and print bed/belt area as well as surrounding parts will be hot during use. Do not touch!
Belts driving the printhead and the main belt will move while printing or operating. Do not touch!
Do not move the device during use.
Declaration of conformity
Contact support@ifactory3d.com for full documentation of the declaration of conformity.
3