Y-Hardstops - iFactory3D One Pro Einrichtungsanleitung

V_97971.03
Y-hardstop
Before starting the device, you must loosen the screws in the two Y-hardstops. They serve as
protection for the printhead during transport.
They do not need to be removed entirely; just make sure that the printed part can move
smoothly up and down on the profile.
Tighten the screws again as soon as the printhead position is set (see software manual).
Y-hardstops prevent the nozzle from crashing into the print bed if printing errors occur.
Make always sure that they are tight before the machine is printing.
Also, make sure they are always loosened up when you want to recalibrate the nozzle
position.
Tip: You can loosen the screws on the Y-endstops and push them upwards before leveling.
The printhead will push the hardstops down to Y0-position, where they can be tightened
during leveling.
10