Cleaning; Troubleshooting; Disposal And Environmental Protection; Reference To The Declaration Of Conformity - Walimex Pro RGB TUBE SMALL M10 Gebrauchsanleitung

3. Pull the USB-C plug of the charging cable (20) out of the connection socket (21) on the
underside of the glowstick.
4. Let the glowstick cool down completely.
5. If necessary, remove the glowstick from the tripod.
6. Clean the glowstick and the mini tripod if necessary (see chapter 9).
7. Stow the glowstick and accessories in the article packaging.
NOTICE
NOTE - Always store the glowstick in a dry and dust-free place.
9.

Cleaning

NOTICE
Only clean the components as indicated in the table below. Never allow the glowstick or the
power supply unit to come into contact with moisture or water.
Component
Housing, tripod
NOTICE
Do not use any cleaning agents or solvents! Make sure that no moisture gets into the housing!

10. Troubleshooting

Problem
Glowstick is switched on but
shows no function
Glowstick is not lit

11. Disposal and environmental protection

Please dispose of the luminaire and accessories at the end of their service life at one of the
local disposal centres. This service is free of charge for you.

12. Reference to the declaration of conformity

WALSER GmbH & Co. KG hereby declares that the remote control and the LED luminaire with
integrated radio receiver are conform with the essential requirements and the other relevant
provisions.
26
Cleaning
1. Remove dirt with a dry or damp soft cloth
(non-fluffy, e.g. microfibre cloth).
2. Allow parts to dry completely.
Possible causes
Charging cable is not
plugged in or not plugged in
correctly
Battery is empty
Glowstick is switched off
Glowstick is defective
Remedy
Connect power supply
correctly
Charge glowstick
Switch on glowstick
Please contact our service!
Repairs may only be carried
out by a qualified electrician