Connecting The Gas Pipe; Electrical Connection - Edesa EGG-1240 TI TR CI N Bedienungs- Und Wartungsanleitung

Connecting the gas pipe

Connect the product to the gas pipe in accordance with the applicable laws and only after
making the necessary adjustments for this type of gas-powered appliances. Otherwise, apply
the steps described in paragraph "replacing the injectors". For supplying with liquid gas, use
pressure controllers in accordance with the applicable laws.
Gasket
Pipe
Ventilating the area
As per the applicable rules/laws, ensure that there are holes directed towards the outer
environment or a ventilating duct that provides proper air flow.
Make sure that the holes:
1. Have a passage section of at least 100 cm
2. Cannot be obstructed either from the inside or from the outside;
3. Do not have any guards to block air passage;
4. Are high enough not to force the discharge of combustion products.
If the holes are on the wall of an adjoining room, the said room must be directly ventilated and
it must not be:
i. A bedroom
ii. A common room with the installation area
iii. A room where there is risk of fire.
Before testing the product, make sure that there is no pressure decrease due to malfunction of
another product used in the room where the ventilation holes are present. Ensure ventilation
between the two areas with continuous free openings, e.g. increasing the distance between
the door and the floor. Discharge of combustion products must be performed with a hood so
that they can be discharged either directly or through a chimney/flue.

Electrical connection

Edesa hob has a three-pole supply cable with a free terminal. If the hob will remain
continuously connected to the mains, for high voltage category III, install a cut-off device,
Fit the gasket, which is provided to ensure that the
gas pipe is fitted tightly. You must observe the
applicable rules regarding gas installations. After
making the connection, check with soapy water if
there is any leakage.
Figure 2
2 ;
13